Victorian Arched Cast Electric Fire (14.5″ / 37.5cm)
Inset Tray Electric Fire
SUITABLE FOR GALLERY CASTS: JUBILEE/LYTTON/CELTIC/PEMBROKE/BOLTON
This is a new Victorian arched cast electric fire designed to fit in arched casts. It is remote controlled but can be also used manually at the bottom of the fire, but please check measurements that are below or contact us for any further information or questions if you need too.
Please note the fire comes in 2 sections you have the base of which the heat comes out and then fixed coal section that sits on top for the coal effect.
Measurements:
Base:
Width: 28cm
Front to Back: 14cm
Height: 9.5cm (with legs extended 11.5cm)
Fixed Coal Section:
Width: 37cm
Height: 19cm
Width at the back: 25cm
Front to Back: (deepest section in the middle) 15cm
Complete Inset Fire:
Max height once the coal section is on the base is 31cm with the legs extended 33cm.
Max Width is 37cm
Please note: If purchased outside UK Mainland – Warranty purposes are only covered for Uk Mainland you will have to pay for return postage back to us then the rest is covered. Please call us on 01492 532509 if you want to discuss further.
The Victorian arched cast electric fire effect will brighten up your fireplace and can replace a coal fire, there is minimal fitting required.
Just set it up and plug it in. Comes with a kettle lead connection that fits into the front of the fire.
You can use the Electric fire in the summer and at winter go back to a real coal fire.
Please note when using the fan heater that is underneath the fire , if there is an ashpan cover on the fire front IT must be removed.
Heat output is 1800W and it has a 900W setting as well.
The light effect can be used without the heat if required, also has different light settings.
